Fiberglass spreader arms
Shown here is one of the six spreaders which are made up of three sections each, all are tough fiberglass with walls 1/8 inch thick. The smallest slips into the middle section
which in turn, slips into the bottom section, which is one inch in diameter. Stop clamps already installed, make assembly of the spreaders a whiz right out of the box.
The sections are held by the tension of the support cords and can be easily disassembled for portability. If desired, the sections can be glued together permanently with Liquid
Nail adhesive or even a small bolt at the end of each telescoped section. However, this is not necessary for proper operation.
The wire attachments are already completely assembled, installed and positioned at the proper place for installation of wire sets. Only minor adjustment is required if any, for
proper tension of the wires.
The spreader arms are shipped in light grey color and need no paint. However, you can paint them with latex paint in the color of your preference such as black, light blue shown
below or even camouflage.
which in turn, slips into the bottom section, which is one inch in diameter. Stop clamps already installed, make assembly of the spreaders a whiz right out of the box.
The sections are held by the tension of the support cords and can be easily disassembled for portability. If desired, the sections can be glued together permanently with Liquid
Nail adhesive or even a small bolt at the end of each telescoped section. However, this is not necessary for proper operation.
The wire attachments are already completely assembled, installed and positioned at the proper place for installation of wire sets. Only minor adjustment is required if any, for
proper tension of the wires.
The spreader arms are shipped in light grey color and need no paint. However, you can paint them with latex paint in the color of your preference such as black, light blue shown
below or even camouflage.
| The spreader walls are 1/8 inch thick for strength to survive all but the worst storms. |
| The aluminum P clamps with insulated covering for anchoring the wire sets are attached to the spreaders with stainless steel clamps. |
Hours: Mon - Fri 8:30 - 5:00 CT
Sales & Support: 1-888-694-3923 (Toll Free)
E mail: kio@k4kio.com
Sales & Support: 1-888-694-3923 (Toll Free)
E mail: kio@k4kio.com
 | |  | |  | |  | |  |
KIO Technology